12/15/2023 0 Comments Loxone extension offline![]() To pair Air devices automatically via the Air, the Air device must be added in the Config. The automatic pairing of Air devices can be activated in the properties of the Air interface for a certain duration: The Loxone App, under Settings, also supports searching for and pairing Air devices. Now the added devices are ready for use and the functions are available in the Periphery Tree in Loxone Config. To apply the changes, save the program in the Miniserver. By clicking on the button with the arrow pointing right, the old device is replaced with the new one in the program. Select the device to be added and the device to be replaced. This is useful when a device needs to be replaced or devices are added to a pre-configured program. ![]() You can also replace an existing device with a new device of the same type that was found in the search. You can display them by clicking the button Show my Air devices. The right window lists all the devices that are currently part of the program. Select the desired device, assign a name, room and installation location and add it to the programming using the Pair Device or + button. This allows you to assign and name the devices correctly. Devices with a status LED will flash it, light fixtures pulse a white light, other devices such as the Loxone Touch emit an audible click. If you select a device here, it will identify itself in different ways. The window that opens will list all Air devices that are in pairing mode. To search for Air devices, first click on an Air Interface in Loxone Config, and then activate Air Device Search On most devices, this is done by pressing the pairing button or power cycling the device. In this case, you have to activate the pairing mode manually. If an Air device blinks only orange, then it was previously paired, but can no longer establish a connection. Briefly remove the battery and then reinsert it to reactivate pairing mode, if necessary. On battery powered Air devices the pairing mode is only active for 5 minutes to conserve energy. You can find the exact pairing mode signal in the documentation of the respective Air device. On most Air devices, the status LED will indicate this by flashing red/green/orange. In delivery state, pairing mode will be active after the power supply has been established. The Extension starts after switching on the power supply, and the status LED will flash orange after a short time when the connection to the Miniserver is established.Īll Air devices have to be paired in Loxone Config via the pairing mode. Alternatively, a flat adhesive SMA antenna is available. If the enclosure is made of metal, install the antenna outside the enclosure using the SMA extension cable that is supplied with the rod antenna. To ensure optimal signal quality, use the optionally available rod antenna. The Air Base Extension is installed on a DIN rail in a suitable enclosure.Ĭonnect the power supply and Link communication to the Miniserver and install the antenna. The Miniserver Go features an integrated Air Base Extension.ĭatasheet Air Base Extension Table of Contents The 868MHz frequency band is used for communication (US: 902 MHz to 928 MHz). Up to 128 Air devices can be integrated with one Air Base Extension. The Loxone Air Base Extension is used to extend the Miniserver, and allows the integration of various devices like sensors, actuator or lighting products that are equipped with the Loxone Air wireless technology.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |